CoS Hardware Resource Configuration
Fixed Switch Configuration Guide 17-13
4 4 * * enabled
5 5 * * enabled
6 6 * * enabled
7 7 * * enabled
Use the show cos port-resource flood-ctrl command to display the flood control unit and rate to
flood control resource mapping:
System(su)->show cos port-resource flood-ctrl 1.0
'?' after the rate value indicates an invalid rate value
Group Resource Type Unit Rate Rate Limit Action
Index type
--------- ----------- ---------- ---- ---------- --------------- ------
1.0 ucast flood-ctrl pps 3000 drop none
1.0 mcast flood-ctrl pps disable drop none
1.0 bcast flood-ctrl pps disable drop none
Use the show cos port-config flood-ctrl command to display the port group name and assigned
ports for port group 1.0.
System(su)->show cos port-config flood-ctrl 1.0
Flood control Port Configuration Entries
-----------------------------------------
Port Group Name :
Port Group :1
Port Type :0
Assigned Ports :ge.1.3
----------------------------------------------------------------------
Enabling CoS State
CoS state is a global setting that must be enabled for CoS configurations to be applied to a port.
When CoS state is enabled, controls configured for CoS supersede port level controls for priority
queue mapping and IRL. These port level settings can be configured independent of CoS state, but
will have no affect while CoS is enabled. Disabling CoS results in the restoration of current port
level settings.
Use the set cos state enable command to enable CoS state globally for this system.
Use the set cos state disable command to disable CoS state globally for this system.
Use the show cos state command to display the current status of CoS state.
To Next Page
Loading...
Need help?
General