Enterasys C5G124-24 User Manual

Configuring Enterasys Discovery Protocol
13-10 Configuring Neighbor Discovery
System(rw)->set lldp port tx-tlv med-loc ge.1.1-6
LLDP Display Commands
Table 13-2 lists LLDP show commands.
Refer to your device’s CLI Reference Guide for a description of the output of each command.
Configuring Enterasys Discovery Protocol
Enterasys Discovery Protocol Configuration Commands
Table 13-3 lists Enterasys Discovery Protocol configuration commands.
Table 13-2 LLDP Show Commands
Task Command
Display LLDP configuration information. show lldp
Display the LLDP status of one or more ports. show lldp port status [port-string]
Display the ports that are enabled to send an LLDP
notification when a remote system change has been
detected or an LLDP-MED notification when a
change in the topology has been sensed.
show lldp port trap [port-string]
Display information about which optional TLVs have
been configured to be transmitted on ports.
show lldp port tx-tlv [port-string]
Display configured location information for one or
more ports.
show lldp port location-info [port-
string]
Display the local system information stored for one
or more ports.
show lldp port local-info [port-string]
Display the remote system information stored for a
remote device connected to a local port.
show lldp port remote-info [port-
string]
Display LLDP port network policy configuration
information.
show lldp port network policy {all |
voice | voice-signaling | guest-voice |
guestvoice-signaling | software-voice |
video-conferencing | streaming-video |
videosignaling} [port-string]
Table 13-3 Enterasys Discovery Protocol Configuration Commands
Task Command
Enable or disable the Enterasys Discovery Protocol
on one or more ports.
set cdp state {auto | disable | enable}
[port-string]
Set a global Enterasys Discovery Protocol
authentication code.
set cdp auth auth-code
Set the message interval frequency (in seconds) of
the Enterasys Discovery Protocol.
set cdp interval frequency
Set the hold time value for Enterasys Discovery
Protocol configuration messages.
set cdp hold-time hold-time

Enterasys C5G124-24 Specifications

General

Brand	Enterasys
Model	C5G124-24
Category	Switch
Language	English