sFlow
Fixed Switch Configuration Guide 18-15
Table 18-7 lists the commands to display sFlow information and statistics. Refer to the CLI
Reference for your platform for command details.
Table 18-8 lists the commands to manage sFlow. Refer to the CLI Reference for your platform for
command details.
Table 18-7 Displaying sFlow Information
Task Command
to display the contents of the sFlow Receivers Table, or to
display information about a specific sFlow Collector listed in
the table
show sflow receivers [index]
To display information about configured poller instances show sflow pollers
To display information about configured sampler instances. show sflow samplers
To display the interface used by the sFlow Agent when
sending sampling datagrams to the sFlow Collector
show sflow interface
To display information about the sFlow Agent. show sflow agent
Table 18-8 Managing sFlow
Task Command
To delete a receiver/Collector from the sFlow Receivers
Table, or to return certain parameters to their default values
for the specified Collector.
clear sflow receiver index [ip |
maxdatagram | owner [timeout] |
port]
To change the poller interval or to remove poller instances. clear sflow port port-string
poller [interval]
To change the sampler rate or maximum header size, or to
remove sampler instances.
clear sflow port port-string
sampler [maxheadersize | rate]
To clear the management interface used by the sFlow
Agent back to the default of the Host VLAN.
clear sflow interface
To Next Page
Loading...
Need help?
General