Fixed Switch Configuration Guide 4-1
4
System Configuration
This chapter provides basic system configuration information in the following areas:
Factory Default Settings
The following tables list factory default settings available on the Enterasys fixed switches.
For information about... Refer to page...
Factory Default Settings 4-1
Initial Configuration Overview 4-5
Advanced Configuration Overview 4-6
Licensing Advanced Features 4-8
SNTP Configuration 4-11
DHCP Configuration 4-16
Telnet Overview 4-23
SSH Overview 4-24
MAC Address Settings 4-24
Configuring Node Aliases 4-26
Table 4-1 Default Settings for Basic Switch Operation
Feature Default Setting
Switch Mode Defaults
CDP discovery protocol Auto enabled on all ports.
CDP authentication code Set to 00-00-00-00-00-00-00-00
CDP hold time Set to 180 seconds.
CDP interval Transmit frequency of CDP messages set to 60 seconds.
Cisco discovery protocol Auto enabled on all ports.
Cisco DP hold time Set to 180 seconds.
Cisco DP interval timer Set to 60 seconds.
Community name Public.
To Next Page
Loading...
Need help?
General