Enterasys C5G124-24

RMON
Fixed Switch Configuration Guide 18-7
• startup - (Optional) Specifies the alarm type
generated when this event is first enabled
• rthresh - (Optional) Specifies the minimum
threshold that will cause a rising alarm
• fthresh - (Optional) Specifies the minimum
threshold that will cause a falling alarm
• revent - (Optional) Specifies the index
number of the RMON event to be triggered
when the rising threshold is crossed
• fevent - (Optional) Specifies the index
number of the RMON event to be triggered
when the falling threshold is crossed
• owner - (Optional) Specifies the
management station owner for this entry
4. Enable a configured alarm entry. set rmon alarm status index enable
5. Configure RMON probe variable thresholds that
will trigger an event if crossed by a sampled
probe.
• index - Specifies the entry for this set of event
properties
• description - (Optional) Specifies a text
string description for this event
• type - (Optional) Specifies the event
notification type for this entry
• community - (Optional) Specifies an SNMP
community name to use if the message type
is set to trap
• owner - (Optional) Specifies the
management station owner for this entry
set rmon event properties index
[description description] [type
{none | log | trap | both}]
[community community] [owner
owner]
6. Enable a configured event entry. set rmon event status index enable
7. Configure an RMON channel entry to match
packets by a filter equation.
• index - Specifies the entry value for this
channel entry
• port-string - Specifies the port on which
RMON will monitor traffic
•
accept - (Optional) Specifies the filters action
for this entry
• control - (Optional) Enables or disables
control of the flow of data through this
channel
• description - (Optional) Specifies a
description for this channel
• owner - (Optional) Specifies the management
station owner for this entry
set rmon channel index port-string
[accept {matched | failed}]
[control {on | off}] [description
description] [owner owner]
Procedure 18-1 Configuring Remote Network Monitoring (continued)
Step Task Command(s)