HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

21
• After you configure the undo ppp mp fragment enable command on an interface, the settings
configured with the ppp mp lfi and ppp mp min-fragment commands become invalid on the
interface.
• When MP binding is based on descriptor only, users cannot be differentiated. To bind users to
different MP bundles, set the binding mode to both.
• When MP binding is based on authentication username only, peer devices cannot be
differentiated. If an MP bundle involves multiple devices, set the binding mode to both.
• For a VT interface, if a static route is used, specify the next hop rather than the outgoing
interface. If the outgoing interface must be specified, make sure that the physical interfaces
bound to the VT are active to ensure normal transport of packets.
• For more information about configuring MP parameters in Dialer interface view, see
"Configuring DCC."
To configure other optional parameters:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create an MP VT interface
or enter dialer interface view.
interface
{
dialer
|
virtual-template
} number
The
interface virtual-template
command also leads you to VT
interface view.
3. Set the binding mode.
ppp mp binding-mode
{
authentication
|
both
|
descriptor
}
Optional.
By default, MP binding is based
on both the PPP authentication
username and the descriptor.
4. Set the maximum number of
links allowed in an MP
bundle.
ppp mp max-bind
max-bind-num
Optional.
16 by default.
This command is available in VT
interface view and dialer interface
view.
Inappropriate use of this
command can cause PPP
performance degradation. Make
sure you understand the impact of
this command on your network
before you use it.
5. Set the minimum number of
links required in an MP
bundle.
ppp mp min-bind
min-bind-num
Optional.
This command is available only in
dialer interface view.
By default, the minimum number
of links in an MP bundle is 0, that
is, MP dialup depends on traffic
detection.
6. Configure the MP sort buffer
size factor.
ppp mp sort-buffer-size
size
Optional.
1 by default.
The MP sort buffer size = The
number of channels in the current
MP bundle × size.
7. Enable MP fragmentation.
ppp mp fragment enable
Optional.
Enabled by default.
8. Set the minimum size of MP
fragments.
ppp mp min-fragment
size
Optional.
128 bytes by default.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English