To disconnect a fiber-optic cable from an optical transceiver installed in the QFX Series:
1. (Recommended) Disable the port in which the transceiver is installed by including the disable statement
at the [edit interfaces] hierarchy level for the specific interface.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
WARNING: Do not stare into the laser beam or view it directly with optical
instruments even if the interface has been disabled.
2. Carefully unplug the fiber-optic cable connector from the transceiver.
3. Cover the transceiver with a rubber safety cap.
WARNING: Do not leave a fiber-optic transceiver uncovered except when inserting
or removing a cable. The rubber safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Cover the fiber-optic cable connector with the rubber safety cap.
RELATED DOCUMENTATION
Connecting a Fiber-Optic Cable to a QFX Series Device | 488
Maintaining Fiber-Optic Cables in a QFX Series Device | 491
Disconnect a Fiber-Optic Cable
Juniper Networks devices have optical transceivers to which you can connect fiber-optic cables.
Before you begin to disconnect a fiber-optic cable from an optical transceiver, ensure that you have taken
the necessary precautions for safe handling of lasers. See Laser and LED Safety Guidelines and Warnings.
487
To Next Page
Loading...
