•
Antistatic bag, one for each component.
•
If you are returning the chassis, an appropriate screwdriver for the mounting screws used on your rack
or cabinet.
Packing a QFX5100 Switch for Shipping
To pack a QFX5100 switch for shipping:
1. Power down the switch and remove the power cables. See “Powering Off a QFX5100 Device” on
page 409.
2. Remove the cables that connect the QFX5100 switch to all external devices.
3. Remove all field-replaceable units (FRUs) from the switch.
4. Have one person support the weight of the switch while another person unscrews and removes the
mounting screws.
5. Remove the switch from the rack or cabinet (see “QFX5100 Installation Safety Guidelines” on page 218)
and place the switch in an antistatic bag.
6. Place the switch in the shipping carton.
7. Place the packing foam on top of and around the switch.
8. If you are returning accessories or FRUs with the switch, pack them as instructed in “Packing QFX5100
Switch Components for Shipping” on page 608.
9. Replace the accessory box on top of the packing foam.
10. Close the top of the cardboard shipping box and seal it with packing tape.
11. Write the RMA number on the exterior of the box to ensure proper tracking.
Packing QFX5100 Switch Components for Shipping
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not fit together on one level in the shipping box.
608
To Next Page
Loading...
Need help?
General
