Juniper QFX5110 Series User Manual

CHAPTER 22
Installing a QFX5110 Switch
IN THIS CHAPTER
Standalone Installation Overview | 262
Unpacking a QFX5110 | 263
Mounting a QFX5110 in a Rack | 264
Connect the QFX5110 to Earth Ground | 267
Connecting AC Power to a QFX5110 | 268
Connecting DC Power to a QFX5110 | 271
Standalone Installation Overview
You can mount a QFX5110:
•
Flush with the front of a 19-in. four-post rack. Use the standard mounting brackets provided with the
switch for this configuration.
•
Recessed 2 in. (5 cm) from the front of a 19-in. four-post rack. Use the extension bracket provided in
the standard mounting kit for this configuration.
To install and connect a QFX5110:
1. Follow the instructions in Unpacking a QFX5110.
2. Determine how the switch is to be mounted.
Flush or recessed-mounted in a rack, seeMounting a QFX5110 in a Rack .
3. Follow the instructions in:
a. Connect the QFX5110 to Earth Ground
b. Connecting the QFX5110 to Power
262

Juniper QFX5110 Series Specifications

General

Rack Units	1U
Operating System	Junos OS
Form Factor	Fixed
Management	CLI, SNMP, NETCONF
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 90% non-condensing
AC Power Input	100-240 VAC
Power Supply	Redundant, hot-swappable