•
“Mounting an EX4300 Switch on Four Posts of a Rack or Cabinet” on page 359 (by using the separately
orderable four-post rack-mount kit)
•
“Mounting an EX4300 Switch on a Wall” on page 363 (by using the separately orderable wall-mount
kit)
5. Follow instructions in Connect Earth Ground to an EX Series Switch.
6. Follow instructions for connecting power as appropriate for your site:
•
Connecting AC Power to an EX4300 Switch
•
Connecting DC Power to an EX4300 Switch
7. Register your product by following instructions in Register Products—Mandatory for Validating SLAs.
8. Perform initial configuration of the switch by following the instructions in Connecting and Configuring
an EX Series Switch (CLI Procedure) or Connecting and Configuring an EX Series Switch (J-Web Procedure).
9. Set the switch’s management options by following the instructions in:
•
Connect a Device to a Network for Out-of-Band Management on page 325
•
Connect a Device to a Management Console Using an RJ-45 Connector
•
Connect an EX Series Switch to a Management Console Using the Mini-USB Type-B Console Port
RELATED DOCUMENTATION
Rack Requirements | 115
Cabinet Requirements | 120
Clearance Requirements for Airflow and Hardware Maintenance for EX4300 Switches | 126
Unpacking an EX4300 Switch
EX4300 switches are shipped in a cardboard carton, secured with foam packing material. The carton has
an accessory compartment.
CAUTION: EX4300 switches are maximally protected inside the shipping carton. Do
not unpack the switches until you are ready to begin installation.
354
To Next Page
Loading...
