Juniper QFX5110 Series User Manual

[edit virtual-chassis]
user@device# set member 0 fabric-tree-root
user@device# set member 1 fabric-tree-root
user@device# set member 4 fabric-tree-root
user@device# set member 5 fabric-tree-root
NOTE: This option can also be configured anytime later during VCF operation if you observe
internal VCF multicast traffic flow issues with default MDTs.
RELATED DOCUMENTATION
Understanding Virtual Chassis Fabric Configuration | 4
Adding a Device to a Virtual Chassis Fabric | 394
Removing a Device From a Virtual Chassis Fabric | 405
Understanding Virtual Chassis Fabric Components
Preprovisioning a Virtual Chassis Fabric | 373
Understanding Traffic Flow Through a Virtual Chassis Fabric
Preprovisioning a Virtual Chassis Fabric
Preprovisioning a Virtual Chassis Fabric (VCF) configuration allows you to assign the member ID and role
for each device in the VCF. See Understanding Virtual Chassis Fabric Components and “Understanding Virtual
Chassis Fabric Configuration” on page 4 for details on the supported devices that can be interconnected
into a non-mixed or mixed VCF.
Before you begin:
•
Update all devices to the same version of Junos OS that supports VCF. See Installing Software Packages
on QFX Series Devices or Installing Software on an EX Series Switch with a Virtual Chassis or Single Routing
Engine (CLI Procedure).
373

Juniper QFX5110 Series Specifications

General

Rack Units	1U
Operating System	Junos OS
Form Factor	Fixed
Management	CLI, SNMP, NETCONF
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 90% non-condensing
AC Power Input	100-240 VAC
Power Supply	Redundant, hot-swappable