Juniper QFX5110 Series - Packing a QFX3500 Device or Component for Shipping

•
Place individual FRUs in antistatic bags.
•
Ensure that the components are adequately protected with packing materials and packed so that the
pieces are prevented from moving around inside the carton.
•
Close the top of the cardboard shipping box and seal it with packing tape.
•
Write the RMA number on the exterior of the box to ensure proper tracking.
RELATED DOCUMENTATION
Returning a QFX3600 or QFX3600-I Device or Component for Repair or Replacement | 617
Packing a QFX3500 Device or Component for Shipping
IN THIS SECTION
Packing a QFX3500 Device for Shipping | 612
Packing QFX3500 Device Components for Shipping | 612
If you are returning a QFX3500 device or component to Juniper Networks for repair or replacement, pack
the item as described in this topic.
Before you pack a QFX3500 device or component:
•
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See “Prevention of Electrostatic Discharge Damage” on page 242.
•
Retrieve the original shipping carton and packing materials. Contact your JTAC representative if you do
not have these materials, to learn about approved packing materials. See “Contacting Customer Support
to Obtain a Return Materials Authorization for a QFX Series Device or Component” on page 619.
Ensure that you have the following parts and tools available:
•
ESD grounding strap.
•
Antistatic bag, one for each component.
•
If you are returning the chassis, an appropriate screwdriver for the mounting screws used on your rack
or cabinet.
611