Juniper QFX5110 Series User Manual

Figure 239: Location of the Serial Number ID Label on the 4-Port 1-Gigabit Ethernet SFP/10-Gigabit
Ethernet SFP+ Uplink Module for EX4300-48MP Switches
g022469
Serial number ID label
Packing an QFX5110 Device or Component for Shipping
IN THIS SECTION
Packing a QFX5110 Switch for Shipping | 606
Packing QFX5110 Components for Shipping | 606
If you are returning a QFX5110 or component to Juniper Networks for repair or replacement, pack the
item as described in this topic.
Before you pack a QFX5110 or component:
•
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See “Prevention of Electrostatic Discharge Damage” on page 242.
•
Retrieve the original shipping carton and packing materials. Contact your JTAC representative if you do
not have these materials to learn about approved packing materials. See “Contacting Customer Support
to Obtain a Return Materials Authorization for a QFX Series Device or Component” on page 619.
Ensure that you have the following parts and tools available:
•
ESD grounding strap.
•
Antistatic bag, one for each component.
605

Juniper QFX5110 Series Specifications

General

Rack Units	1U
Operating System	Junos OS
Form Factor	Fixed
Management	CLI, SNMP, NETCONF
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 90% non-condensing
AC Power Input	100-240 VAC
Power Supply	Redundant, hot-swappable