•
If you are returning the chassis, an appropriate screwdriver for the mounting screws used on your rack
or cabinet.
This topic describes:
Packing a QFX5110 Switch for Shipping
To pack a QFX5110 for shipping:
1. Power down the switch and remove the power cables. See “Powering Off a QFX5110” on page 406.
2. Remove the cables that connect the QFX5110 to all external devices.
3. Remove all field-replaceable units (FRUs) from the switch.
4. Have one person support the weight of the switch while another person unscrews and removes the
mounting screws.
5. Remove the switch from the rack or cabinet (see QFX5110 Installation Safety Guidelines) and place the
switch in an antistatic bag.
6. Place the switch in the shipping carton.
7. Place the packing foam on top of and around the switch.
8. If you are returning accessories or FRUs with the switch, pack them as instructed in “Packing QFX5110
Components for Shipping” on page 606.
9. Replace the accessory box on top of the packing foam.
10. Close the top of the cardboard shipping box and seal it with packing tape.
11. Write the RMA number on the exterior of the box to ensure proper tracking.
Packing QFX5110 Components for Shipping
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not fit together on one level in the shipping box.
606
To Next Page
Loading...
Need help?
General
