Keithley 2450

Section
4: Source-measure considerations Model 2450 Interactive SourceMeter® Instrument
Reference Manual
4-26 2450-901-01 Rev. B/September 2013
Terminal reset values
Setting Default value on
reset
TERMINALS button
:ROUTe:TERMinals (on page 6-35)
smu.measure.terminals (on page 8-124)
Front
Measurement reset values
Setting Default value on
reset
Not available from front panel
[:SENSe[1]]:COUNt (on page 6-42)
smu.measure.count (on page 8-97)
1
MENU > Measure > Filter/Math > Filter Count
[:SENSe[1]]:<function>:AVERage:COUNt (on page 6-43)
smu.measure.filter.count (on page 8-100)
10
MENU > Measure > Filter/Math > Filter State
[:SENSe[1]]:<function>:AVERage[:STATe] (on page 6-44)
smu.measure.filter.enable (on page 8-101)
Off
MENU > Measure > Filter/Math > Filter Type
[:SENSe[1]]:<function>:AVERage:TCONtrol (on page 6-45)
smu.measure.filter.type (on page 8-102)
Repeat
SETTINGS swipe > Auto Zero
[:SENSe[1]]:<function>:AZERo[:STATe] (on page 6-46)
smu.measure.autozero.enable (on page 8-89)
On
Not available from front panel
[:SENSe[1]]:<function>:DELay:USER<n> (on page 6-47)
smu.measure.userdelay[N] (on page 8-126)
0
MENU > Measure > Settings (when instrument is set to
source current and measure resistance)
[:SENSe[1]]:<function>:OCOMpensated (on page 6-49)
smu.measure.offsetcompensation (on page 8-117)
Off
SETTINGS swipe > NPLCs
[:SENSe[1]]:<function>:NPLCycles (on page 6-48)
smu.measure.nplc (on page 8-116)
1
FUNCTION key
[:SENSe[1]]:FUNCtion[:ON] (on page 6-49)
smu.measure.func (on page 8-103)
Current
HOME > Range
[:SENSe[1]]:<function>:RANGe:AUTO (on page 6-50)
smu.measure.autorange (on page 8-86)
On
MENU > Measure > Settings > Auto Range Low Limit
[:SENSe[1]]:<function>:RANGe:AUTO:LLIMit (on page 6-51)
smu.measure.autorangelow (on page 8-88)
Current: 1e-8 amps
(10 nA)
Voltage: 20 V
Resistance: 20
ohms
Not available from front panel
[:SENSe[1]]:<function>:RANGe:AUTO:ULIMit (on page 6-
52)
smu.measure.autorangehigh (on page 8-87)
Voltage: 0.20
Resistance: 2e5
HOME > Measure Range
[:SENSe[1]]:<function>:RANGe[:UPPer] (on page 6-53)
smu.measure.range (on page 8-117)
AUTO