Keithley 2450

Section
4: Source-measure considerations Model 2450 Interactive SourceMeter® Instrument
Reference Manual
4-28 2450-901-01 Rev. B/September 2013
Buffer reset values
Setting Default value on
reset
Not available from front panel
:TRACe:FILL:MODE (on page 6-112
)
bufferVar.fillmode (on page 8-19)
Default buffers:
Continuous
User-defined
buffers: Once
Not available from front panel
:TRACe:LOG:STATe (on page 6-113
)
bufferVar.logstate (on page 8-22)
Default buffers: ON
User-created
buffers: OFF
Trigger reset values
Setting Default value on
reset
Not available from front panel
:TRIGger:BLENder<n>:MODE (on page 6-125)
trigger.blender[N].orenable (on page 8-166)
AND
Not available from front panel
:TRIGger:DIGital<n>:IN:EDGE (on page 6-150)
trigger.digin[N].edge
Falling edge
Not available from front panel
:TRIGger:DIGital<n>:OUT:LOGic (on page 6-151)
trigger.digout[N].logic (on page 8-174)
Positive
Not available from front panel
:TRIGger:DIGital<n>:OUT:PULSewidth (on page 6-152
)
trigger.digout[N].pulsewidth (on page 8-174)
10e-6
Not available from front panel
:TRIGger:DIGital<n>:OUT:STIMulus (on page 6-153
)
trigger.digout[N].stimulus (on page 8-175)
None
Not available from front panel
:TRIGger:LAN<n>:IN:EDGE (on page 6-155)
trigger.lanin[N].edge (on page 8-177)
Either edge
Not available from front panel
:TRIGger:LAN<n>:OUT:IP:ADDRess (on page 6-158)
trigger.lanout[N].ipaddress (on page 8-182)
0.0.0.0
Not available from front panel
:TRIGger:LAN<n>:OUT:PROTocol (on page 6-159)
trigger.lanout[N].protocol (on page 8-183)
TCP
Not available from front panel
:TRIGger:LAN<n>:OUT:STIMulus (on page 6-159
)
trigger.lanout[N].stimulus (on page 8-184)
None
Not available from front panel
:TRIGger:TIMer<n>:COUNt (on page 6-167
)
trigger.timer[N].count (on page 8-216)
1
Not available from front panel
:TRIGger:TIMer<n>:DELay (on page 6-168)
trigger.timer[N].delay (on page 8-217)
10e-6
Not available from front panel
:TRIGger:TIMer<n>:STARt:FRACtional (on page 6-169)
trigger.timer[N].start.fractionalseconds (on page 8-221)
0