Keithley 2450 - Page 852

Model 2450
Interactive SourceMeter® Instrument Reference Manual Appendix D:
Model 2450 in a Model 2400 application
2450-901-01 Rev. B/September 2013 D-9
Model 2400 command
:CALCulate2:LIMit<x>:UPPer[:DATA]
:CALCulate2:LIMit<x>:UPPer[:DATA]?
Model 2450 command
:CALCulate2:<function>:LIMit<y>:UPPer[:DATA] (on page 6-18), where
<function> is VOLTage[:DC], CURRent[:DC], or RESistance and <y> is
1 or 2.
Notes
Note that this only available for two limits in the Model 2450.
Model 2400 command
:CALCulate2:LIMit<x>:UPPer:SOURce2
:CALCulate2:LIMit<x>:UPPer:SOURce2?
Model 2450 command
Not available
Notes
Model 2400 command
:CALCulate2:NULL:ACQuire
Model 2450 command
[:SENSe[1]]:<function>:RELative:ACQuire (on page 6-56
), where <function>
is
VOLTage[:DC]
,
CURRent[:DC]
, or
RESistance
Notes
Model 2400 command
:CALCulate2:NULL:OFFSet
:CALCulate2:NULL:OFFSet?
Model 2450 command
[:SENSe[1]]:<function>:RELative (on page 6-55), where <function> is
VOLTage[:DC], CURRent[:DC], or RESistance
[:SENSe[1]]:<function>:RELative?
Notes
Model 2400 command
:CALCulate2:NULL:STATe
:CALCulate2:NULL:STATe?
Model 2450 command
[:SENSe[1]]:<function>:RELative:STATe (on page 6-57
), where <function> is
VOLTage[:DC]
,
CURRent[:DC]
, or
RESistance
Notes
CALCulate3 subsystem
Model 2400 command
:CALCulate3:DATA?
Model 2450 command
Not available
Notes
Use reading buffers; see the TRACe subsystem (on page 6-107).
Model 2400 command
:CALCulate3:FORMat
:CALCulate3:FORMat?
Model 2450 command
Not available
Notes
Use reading buffers; see the TRACe subsystem (on page 6-107).
CONFigure
Model 2400 command
:CONFigure
:CONFigure?
Model 2450 command
Not available
Notes