Konica Minolta 7255 - Page 13

Features of the Konica 7255/7272 (continued)
xi
• Output Mode for Machine with FS-110/111/210 Finisher Installed:
Non-Sort, Sort, Staple-Sort, and Group modes using the primary (main)
tray
Non-Sort Face Down exit, Non-Sort Face Up exit, Group Face Down exit,
and Group Face Up exit modes using the secondary (sub) tray
Fold, Stitch & Fold, and Three-Fold modes using the booklet tray (FS-210
only)
Selects an output tray and output mode on the Output Mode popup menu.
• Output Mode for Machine with SF-101 Shift Tray Installed:
Non-sort, Sort, and Group modes are available.
Selects an output mode on the Output Mode popup menu.
• Output Mode for Machine with no Finisher Installed:
Non-sort, Rotation sort, Group, and Rotation group modes are available in
combination with Face down or Face up exit.
Selects an output mode on the Output Mode popup menu.
• Overlay
Inprints a scanned image onto the copy image.
• Overlay Memory
Stores the overlaying image in HDD and prints a stored image onto the copy
image.
• Paper Capacity
Total 3,600 sheets, including two 500-sheet trays, a 1,500 sheet tray, a
1,000 sheet tray, and a 100-sheet Multi-sheet bypass tray.
Total 7,600 sheets, including 4,000-sheet optional large capacity tray.
• Platen Memory
Scans documents into memory from the platen glass and/or the document
feeder and inserts the pages into another document copied from the
document feeder. If an incompatible function is selected in this mode, the
latter function will not be selected, and an Error message will be displayed.
•Power Saver
Automatically turns off all but nominal power supply after a specified period
of copier inactivity, for optimal efficiency. Power is returned after a brief
warm up period by pressing [POWER SAVER ON/OFF] on the control panel.
• Program Job
Scans documents into memory while designating different copy conditions
for each original, then prints all the documents collectively.