Making Double-Sided Copy (1-2, 2-2) (continued)
3-22
2. Check and specify the original set direction and binding mode.
The Original direction icon is located at the upper left corner of the Basic
Screen.
To change the original set direction, touch SPECIAL ORIGINAL on the Basic
Screen to display the Special Original popup menu, then touch the desired
original direction key to highlight it.
If double-sided originals are upside down on the reverse side and you want to
make single-sided copies of the same direction, touch TOP BIND.
With this feature specified, next step is not needed. Proceed to step 4.
Touch OK to return to the Basic Screen.
3. Select the binding mode.
Touch OUTPUT MODE on the Basic Screen to display the Output Mode
popup menu, then touch the desired binding mode key to highlight it.
Output Mode popup menu with Finisher
Output Mode popup menu without Finisher
To Next Page
Loading...
