Making Double-Sided Copy (1-2, 2-2) (continued)
3-23
FOR DETAILS
Selecting TOP BIND will make copies upside down on the reverse side,
while RIGHT&LEFT BIND copies normally.
Touch OK to return to the Basic Screen.
4. Select additional copy conditions, as desired.
FOR DETAILS
Some incompatible conditions may automatically release the selected
copy mode. In this case, arrange all the settings to be compatible with
the selected copy mode.
5. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-6 for details on setting print quantity.
6. Position originals FACE UP in the document feeder according to
the original direction specified in step 2.
HINTS
• See p. 3-2 to p. 3-4 for details on positioning originals.
• Use RADF store mode (p. 3-33 to p. 3-34) when the original count
exceeds 100.
7. Press [START].
The machine starts to scan originals, then to print duplex copies when ready
for output.
Press [STOP] to suspend the scanning or printing job.
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Finisher
Output Mode
Binding
Mode
Shift Tray
Output Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
To Next Page
Loading...
