Making Double-Sided Copy (1-2, 2-2) (continued)
3-26
5. Select additional copy conditions, as desired.
FOR DETAILS
Some incompatible conditions may automatically release the selected
copy mode. In this case, arrange all the settings to be compatible with
the selected copy mode.
6. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-6 for details on setting print quantity.
7. Press [START] to scan.
The front side image of the double-sided copy will be scanned into memory.
8. Replace the original on the platen glass with the back side image
original, then press [START].
FOR DETAILS
Repeat this step until all originals are scanned.
Memory indicator on the upper right of the Basic Screen allows you to
check the remaining memory.
To delete the scanned data without printing, press [STOP], then touch
CANCEL on the popup menu to be sure the data is deleted.
9. Touch STORE to exit the Store mode.
STORE will return to the normal display.
10. Press [START] to print.
All the data in memory will be output.
Press [STOP] to suspend the printing job.
CAUTION
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
To Next Page
Loading...
