SEQ P1: DT/XY/Ctrls 1–2: X–Y Vol T01–08, 1–3: X–Y Vol T09–16 (X–Y Volume Control T01–08, T09–16)
217
Off (unchecked): X–Y position will not affect the volume.
However, you can use program parameter settings for X–Y
CC or AMS to control the volume.
Equal Amount [Off, On]
This applies only when Enable Volume Control is On.
When Equal Amount is On, the X–Y will fade between all
four X–Y axes while maintaining a total amount of 100%.
This provides a smooth fade between the different sounds,
and is the type of volume control used by classic vector
synths.
Note that this will work best when the Programs assigned to
each of the four axes have equivalent volumes. For instance,
you might create a Song with four Programs, each sounding
at the same volume and assigned to a different axis. You
could then add a fifth Program, assign it to one of the axes,
and then reduce the volumes of both Programs on that axis
by 50%–so that their combined volume is the same as any
one of the other Programs.
Also, when this is checked, the Center Volume parameters
will be grayed out, since Equal Amount sets them
automatically.
When Equal Amount is Off, the individual Track Center
Volume parameters determine the way in which X–Y
position affects volume.
SEQ X–Y CC Control
SEQ switch:
“Enable CC control”
SEQ X–Y Volume Control
SEQ switch:
“Enable Volume control”
X–Y CC MIDI Output
Sequencer
Global switch:
“X–Y MIDI Out”
Track 1
Track 16
Program switch:
“Enable Volume control”
Program X–Y Volume Control
Program switch:
“Enable CC control”
Program X–Y CC Control
X–Y CC MIDI Output
X–Y Modulation of
Track Volume
Track 1–16 Center Volume
and Equal Power settings
X–Y CC Modulation of
Program and FX Parameters
(Global Channel Only)
X Mode and
Y Modes
X+/– and Y+/–
CC Assignments
X Mode and
Y Modes
X+/– and Y+/–
CC Assignments
X–Y Control
Global Controllers
MIDI CC Assignments
Defaults: X=118, Y=119
X–Y Control
MIDI In
(Track Chan.)
X–Y Modulation of
Osc 1–2 Volume
Osc 1–2 Center Volume
and Equal Power settings
X–Y CC Modulation of
Program Parameters
X–Y motion
X–Y Control
MIDI In
(Global Chan.)
X–Y CC Control
X–Y Control
Front panel X–Y control will control the MIDI track specified by
“Track Select” if it is set to the global MIDI channel.
Front panel X–Y control will control tracks of the same
MIDI channel as “Track Select.”
* Depending on the MIDI I/O settings of the KARMA module,
tracks other than the “Track Select” MIDI channel will also be
controlled.
X–Y Synthesis system, Sequencer mode
To Next Page
Loading...
Need help?
General
