5 Provisioning
Overview
....................................................................................................................................................................................................................................
Purpose
This chapter contains the procedures for provisioning the Session
Initiation Protocol (SIP) application in the 5ESS
®
switch.
All provisioning procedures described in this section are performed in
the RC/V menu mode. The RC/V menu mode can be entered from the
RC/V terminal or a Supplemental Trunk Line Workstation (STLWS).
The 5ESS
®
switch Recent Change and Verify (RC/V) interface
provides access to the database through views of the Office
Dependent Data (ODD). Only those views and steps necessary to
provision SIP are covered in this chapter. For complete descriptions of
RC/V views or more information about recent change and verify, refer
to Recent Change Reference, 235-118-258 and Recent Change
Procedures, 235-118-251.
The Provisioning section does not include the procedures for
provisioning traffic measurements.
At the end of this chapter there are additional Provisioning procedures
that may be required for growing and/or changing your already
existing SIP signaling network. Please reference the “Add/Change SIP
Elements within an Existing SIP Network” (5-93) procedures.
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-1