Delete SCTP Associations from Existing Association Set
....................................................................................................................................................................................................................................
Purpose
This section contains the procedure for deleting SCTP associations
from an existing association set.
When to use
Use this procedure to delete an SCTP association from an existing
association set.
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• Association Set name
• Association numbers
Required Conditions
• None
Procedure
............................................................................................................................................................
1
Use the RMV:SCTP,ASSOC command to put the association(s) that
are to be removed from the association set in the CLOSED MAN
state.
Note that any stable SIP-T calls that were established over the
affected associations will no longer be able to signal to the far end,
and therefore will not be able to terminate normally, so it would be
Deprovisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
6-99
To Next Page
Loading...
