Lucent Technologies 5ESS - Analyze Service Selection Change Report

Analyze Service Selection Change Report
....................................................................................................................................................................................................................................
Purpose
This procedure provides an analysis of the service selection change
report which is a result of an automatic or manual action of a
processor group changing its service selection.
When to use
Use this procedure when a service selection change report is
generated.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
None
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• None required.
Required Conditions
• None required.
Procedure
............................................................................................................................................................
1
Analyze the REPT SERV PCRGRP change report generated:
REPT SERV PCRGRP=a-b
PSUPH=a-c-d-e f g
Where:
a = Global switch module number
b = Processor group number
c = Packet switch unit 2 number
d = PSU2 shelf number
e = PH position number
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-85