PH Channel Group Assignment (RC/V 22.16)
....................................................................................................................................................................................................................................
Purpose
The PSU2 Protocol Handler Channel Group Assignments view (22.16)
defines channel groups for protocol handlers equipped on a shelf. A
channel group is a logical identifier for a protocol handler.
When to use
Use this procedure to define a new SIP PH and GQPH.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to 235-105-231, Hardware Change Procedures - Growth.
Admonishments
None.
Before you begin
Protocol Handlers must be grown in on the Equipment Subunit --
Protocol Handler view (22.4) and made operational before Channel
Groups can be assigned on this view.
There is no direct link between the POSITION number on view 22.4
and the GRP number on this view, but there must be enough Protocol
Handlers on view 22.4 to support all the Channel Groups and to
account for spares.
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
• The PHs must be grown in the shelf of the PSU2.
Required Information
• Switching Module (SM) Number
• Packet Switch Unit Number
• Packet Switch Unit Shelf Number
Required Conditions
• Protocol Handler is defined (RC/V 22.4)
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-19
To Next Page
Loading...
