Lucent Technologies 5ESS - Insert SCTP Far Endpoints (RC;V 33.21)

To Next Page

To Previous Page

Insert SCTP Far Endpoints (RC/V 33.21)

....................................................................................................................................................................................................................................

Purpose

SCTP Far Endpoint (RC/V 33.21) defines SCTP far endpoints.

When to use

Use this procedure to define the far SCTP endpoints.

Repeat individual steps of this procedure as required.

Related information

Refer to 235-118-258, Recent Change Reference, for information on

the RC/V system.

Admonishments

None.

Before you begin

Required Tools

• Supplemental Trunk Line Workstation (STLWS) or Recent

Change and Verify (RC/V) terminal

• Access to RC/V Menu Interface

Required Material

• The 5ESS

switch must be running a 5E16.2 FR3 software

release with the SIP for Packet Trunking - NAR feature software.

Required Information

• Far endpoint name

• Destination SCTP port number

• IP address(es) of the far SCTP endpoint(s)

Required Conditions

• Protocol Handler is defined (RC/V 22.4)

• Channel Group is defined (RC/V 22.16)

• Secured Feature 684 is enabled (RC/V 8.22)

• SIP GSM defined (RC/V 5.80)

• Processor Group is defined (RC/V 33.16)

• Internet Protocol (IP) Processor is assigned (RC/V 33.1)

• Ethernet IP interface is defined (RC/V 33.4)

• Internet Protocol routing is defined (RC/V 33.3)

Procedure

............................................................................................................................................................

Select and prepare terminal for RC/V activities.

Provisioning

235-200-118

Issue 3.02B, March 2007

Lucent Technologies

5-59