Lucent Technologies 5ESS - Dump Address Resolution Protocol (ARP) Table

Dump Address Resolution Protocol (ARP) Table
....................................................................................................................................................................................................................................
Purpose
This procedure requests a dump of the ARP tables.
When to use
Use to troubleshoot layer 2 network connectivity problems between
the 5ESS
®
switch and the adjacent router.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
None
Before you begin
Required Tools
• Use of Master Control Center (MCC) or Supplementary Trunk
Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• Refer to RC/V 5.80 for provisioned GSMs.
Required Conditions
• None required.
Procedure
............................................................................................................................................................
1
Request a dump of the ARP table
OP:TCPIP:ARPDMP,CHNG=a-b-c-d;
Where:
a = Global switch module number
b = Packet switch unit 2 number
c = PSU2 shelf number
d = Channel group number
Result:
Generates a dump of the ARP tables for a specific channel
group number.
If no entry is found, then do ping to the adjacent router:
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-89