Add UDP Transport for SIP Signaling to Another Office
....................................................................................................................................................................................................................................
Purpose
This section defines the procedure for making UDP transport available
for SIP signaling to another office.
When to use
Use this procedure when SIP signaling to a new far office is to be
supported by UDP transport
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR5 software
release with UDP Transport for SIP software.
• If the new SIP Packet Group is to be supported by UDP transport
and/or requires SIP without Precondition Procedures, the 5E-XC
â„¢
must be running a 5E16.2 FR5 or later software release that
supports those features.
Required Information
• The UDP port number at the near office, and the IP address and
UDP port number at the far office for SIP signaling.
Required Conditions
• SIP GSM is provisioned
Procedure
............................................................................................................................................................
1
Select and prepare terminal for RC/V activities.
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-109
To Next Page
Loading...
Need help?
General
