Delete All SIP Processor Groups (RC/V 33.16)
....................................................................................................................................................................................................................................
Purpose
The Processor Group view (RC/V 33.16) view is used to delete all
SIP processor groups.
When to use
Use this procedure when SIP is being degrown from the office
entirely.
Related information
Refer to 235-118-258, Recent Change Reference for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
The PH’s will revert to STBY mode on MCC page 118X,Y,X.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
Required Information
• All Processor Group Numbers on all SIP GSMs
Required Conditions
• All SCTP Near Endpoints deleted on RC/V 33.19
• All UDP paths deleted on RC/V 33.24
Procedure
............................................................................................................................................................
1
Dump the PCRGRP/5883 office records. At the MCC or TLWS type
and enter the command:
OP:OFR:FORM=5883;
Deprovisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
6-63
To Next Page
Loading...
Need help?
General
