Feature Activation (RC/V 8.22)
....................................................................................................................................................................................................................................
Purpose
This section describes the procedure for activating Secured Feature
IDs (SFIDs) associated with SIP for Packet Trunking and related
features.
When to use
The following SFIDs must be activated using RC/V 8.22 as described:
• SFID 684 is activated before any other provisioning procedures
are attempted. This procedure is executed only once per office
unless the feature has been intentionally deactivated.
• SFID 769 is activated if SIP without Encapsulated ISUP is
supported.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release or later with the SIP for Packet Trunking - NAR feature
software.
• If UDP transport is to be used for SIP signaling, and/or SIP is to
be supported without precondition procedures, the 5E-XC
â„¢
must
be running a 5E16.2 FR5 software release with software for these
enhancements to the SIP for Packet Trunking feature.
• If SIP without Encapsulated ISUP is supported, the 5E-XC
â„¢
must
be running on the 5E16.2 FR6 software release or later.
• If IP trunking is supported on a DRM, the 5ESS
®
switch must be
running on the 5E16.2 FR9 software release or later.
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-13
To Next Page
Loading...
Need help?
General
