Report Service Selection, Ping and Ethernet Link Status
....................................................................................................................................................................................................................................
Purpose
This procedure requests service selection, ping and Ethernet link
status based on processor group or processor in processor group.
When to use
According to local routine maintenance practices, use this procedure
to obtain the service selection, ping and Ethernet link status of a
processor group.
There two ways to output the same report:
1. Request status based on processor group.
2. Request status based on PSU, shelf, and PH position number.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
None
Before you begin
Required Tools
• Use of Master Control Center (MCC) or Supplementary Trunk
Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• Office Record 5880 for provisioned GSMs.
• Office Record 5883 for provisioned processor groups.
• GSM number.
• PSU number, PSU shelf number, PH position number associated
with identified processor group.
Required Conditions
• At least one serving SIP PH is in service when requesting based
on processor in processor group.
Maintenance Considerations
....................................................................................................................................................................................................................................
7-16
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
Need help?
General
