Insert UDP Path (RC/V 33.24)
....................................................................................................................................................................................................................................
Purpose
The UDP Path view (RC/V 33.24) defines UDP parameters pertaining
to transport of SIP message.
When to use
Use this procedure to define a UDP path when SIP is to be supported
by the UDP transport layer.
Repeat individual steps of this procedure as required.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
RC/V view 33.17 is Case Sensitive. Integrity of capital and lower case
letters must be maintained.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR5 software
release with UDP Transport for SIP software.
Required Information
• UDP Path number
• GSM number
• PSU number (0)
• Processor Group number
• Near-end UDP port
• Far-end IP address
• Far-end UDP port
Provisioning
....................................................................................................................................................................................................................................
5-50
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
