Lucent Technologies 5ESS - Add New SIPT PHE2 IP Processor Group on an Existing SIP GSM

Add New SIPT PHE2 IP Processor Group on an Existing SIP
GSM
....................................................................................................................................................................................................................................
Purpose
This procedure defines the procedure for adding a new SIP PHE2 IP
processor group on an existing SIP GSM.
When to use
Use this procedure to add a new SIP PHE2 IP processor group on an
existing SIP GSM.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-750, Output Messages manuals for additional
information on the Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• SIP GSM Number
• PSU Shelf and position information
Required Conditions
• Available slot to install PHE2 board(s) on PSU shelf(s) with a
DF2.
• Available grounding plate for installing 100BaseT Ethernet
link(s)
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-95