Add New SIP Packet Trunking to Another Office
....................................................................................................................................................................................................................................
Purpose
This section defines the procedure for adding a SIP packet trunking to
another office.
When to use
Use this procedure to add SIP packet trunking to another office
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to 235-080-100, Translations Guide, for information on Office
Records (output reports).
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
• If the new SIP Packet Group is to be supported by UDP transport
and/or requires SIP without Precondition Procedures, the 5E-XC
™
must be running a 5E16.2 FR5 or later software release that
supports those features.
Required Information
• The CLI of the far office.
• The type of transport (SCTP versus UDP) to be used for
signaling to the far office.
• Whether or not the far office supports the Precondition
procedures for SIP.
• The Bearer Network ID of the OIU-IP(s) to be used for the
bearer to the far office.
Provisioning
....................................................................................................................................................................................................................................
5-112
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
