Insert SCTP Near Endpoints (RC/V 33.19)
....................................................................................................................................................................................................................................
Purpose
The SCTP Endpoint (RC/V 33.19) defines the SCTP near endpoints to
a processor group.
When to use
Use this procedure to define the near SCTP endpoints.
Repeat individual steps of this procedure as required.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• Near EP name - Identifies the local SCTP endpoint.
• GSM - Global SM where processor group is located
• Processor Group Number
Required Conditions
• Secured Feature 684 is enabled (RC/V 8.22)
• SIP GSM is defined (RC/V 5.80)
• SCTP Parameters are defined if default is not acceptable (RC/V
33.18)
• Protocol Handler is defined (RC/V 22.4)
• Channel Group is defined (RC/V 22.16)
• Processor Group is defined (RC/V 33.16)
• Internet Protocol Processor is assigned (RC/V 33.1)
• Ethernet Internet Protocol Interface is defined (RC/V 33.4)
Provisioning
....................................................................................................................................................................................................................................
5-56
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
