Insert SIP Parameters (RC/V 5.82)
....................................................................................................................................................................................................................................
Purpose
The SIP-T Parameters Definition view (RC/V 5.82) is used to define
SIP parameter set for the packet trunking application.
When to use
Use this procedure to create a new SIP parameter set to use instead of
the DEFAULT parameter set. The DEFAULT SIP parameter set is
created when the first SIP GSM is inserted. This procedure should
also be used to modify individual parameter values (within the
allowable ranges for each parameter) that are different (non-default)
from the default value.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running on the 5E16.2 FR3 or later
software release with the SIP for Packet Trunking - NAR feature
software.
Required Information
• None.
Required Conditions
• Secured Feature 684 is enabled (RC/V 8.22)
• SIP GSM is defined (RC/V 5.80)
• Secured Feature 769 is enabled (RC/V 8.22) if SIP without
Encapsulated ISUP is used.
Procedure
............................................................................................................................................................
1
Select and prepare terminal for RC/V activities.
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-79
To Next Page
Loading...
Need help?
General
