Lucent Technologies 5ESS - Analyze SCTP Near Endpoint Change Report

Analyze SCTP Near Endpoint Change Report
....................................................................................................................................................................................................................................
Purpose
This procedure provides an analysis of an SCTP near endpoint change
report when an SCTP endpoint autonomously transitions from one
state to another.
When to use
Use this procedure when an SCTP endpoint change report is
generated.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
State transitions associated with manual removals or restorals of an
endpoint are not included.
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• None required.
Required Conditions
• None required.
Procedure
............................................................................................................................................................
1
Analyze the REPT SCTP ENDPOINT change report:
REPT SCTP NEAREPT=a
PCRGRP=c-d-e PSUPH=c-d-f-g SHELF-CHGRP=f-h
PREV-STATE=i NEW STATE=j
Where:
a = Near endpoint name
c = Switching module number
d = Packet switch unit 2 number
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-79