Insert SCTP Association Set (RC/V 33.23)
....................................................................................................................................................................................................................................
Purpose
SCTP Association Set (RC/V 33.23) defines association sets between
existing associations.
When to use
Use this procedure to define association sets.
Repeat individual steps of this procedure as required.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• Association set name
• GSM number
• Association identification number(s)
Required Conditions
• Protocol Handler is defined (RC/V 22.4)
• Channel Group is defined (RC/V 22.16)
• Secured Feature 684 is enabled (RC/V 8.22)
• SIP GSM defined (RC/V 5.80)
• Processor Group is defined (RC/V 33.16)
• Internet Protocol (IP) Processor is assigned (RC/V 33.1)
• Ethernet IP Interface is defined (RC/V 33.4)
• Internet Protocol Routing is defined (RC/V 33.3)
• SCTP Parameters defined (RC/V 33.18)
• SCTP Near Endpoint defined (RC/V 33.19)
Provisioning
....................................................................................................................................................................................................................................
5-68
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
