Lucent Technologies 5ESS - Request SCTP Association Status

Request SCTP Association Status
....................................................................................................................................................................................................................................
Purpose
This procedure requests
• the status of a specific SCTP association,
• the status of a specific SCTP association including the path
status, or
• the status of all associations.
When to use
According to local practices for routine maintenance, use this
procedure to obtain the status of an SCTP association.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
None
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• Office Record 5889 for a listing of identified associations.
Required Conditions
• None required.
Procedure to Obtain Status
of a Specific Association
............................................................................................................................................................
1
Request a status report for a specific association:
OP:STATUS,SCTP,ASSOC=a;
Where:
a = association number
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-11