Insert Call Processing SM (RC/V 5.81)
....................................................................................................................................................................................................................................
Purpose
The SIP-T Call Processing SMs view (RC/V 5.81) defines SM-2000s
that can serve as a call processing SM for SIP calls.
When to use
Use this procedure to disable or enable an SM-2000 from processing
SIP calls.
Repeat individual steps of this procedure as required.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• SM-2000 module
Required Conditions
• Secured Feature 684 is enabled (RC/V 8.22)
• SIP GSM is provisioned (RC/V 5.80)
• Protocol Handler is defined (RC/V 22.4)
• Channel groups are provisioned (RC/V 22.16)
• QPH pipes are provisioned (RC/V 17.24)
• MH pipes are provisioned (RC/V 17.20)
• Global SM/GQPH connectivity is provisioned (RC/V 17.27)
NOTE: The last 3 steps are not required when provisioning a
DRM/VCDX SM for SIP call processing.
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-31
To Next Page
Loading...
