Change IP/SCTP Transport Address for SCTP Near Endpoint
....................................................................................................................................................................................................................................
Purpose
This section contains the procedure for changing the IP/SCTP
transport address for an SCTP near endpoint.
When to use
Use this procedure to change the IP/SCTP transport address for an
SCTP near endpoint.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Refer to the 235-600-700/750, Input/Output Messages manuals for
additional information on the Input and Output commands.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• SCTP Near Endpoint name
• New IP address(es)
Required Conditions
• Use OP:STATUS,SCTP,NEAREPT to verify that the near
endpoint is in the OOS MAN state. If not, use RMV:SCTP,
NEAREPT to put it in the OOS MAN state.
Procedure
............................................................................................................................................................
1
Select and prepare terminal for RC/V activities.
Reference:
“Select and Prepare Terminal” (5-11)
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-121
To Next Page
Loading...
