Resolve SCTP Association Problems
....................................................................................................................................................................................................................................
Purpose
This procedure identifies methods for resolving associations with
CLOSED status.
When to use
Use this procedure to restore a SCTP association when an association
transitions from
ESTABLISHED or DEGRADED to CLOSED or a status
request indicates
CLOSED.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
Unconditionally removing an association can be service-affecting
causing the shutdown of traffic.
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• Association number to be recovered is known.
Required Conditions
• Association status is
CLOSED.
Procedure
............................................................................................................................................................
1
If the status is CLOSED MAN, restore the association:
RST:SCTP,ASSOCIATION=a;
Where:
a = association number
Result:
If restoral fails, then refer to the SIP for Packet Trunking
Corrective Maintenance procedure, Restore SCTP Association,
235-200-118.
Maintenance Considerations
....................................................................................................................................................................................................................................
7-64
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
Need help?
General
