Lucent Technologies 5ESS - Request Manual Service Selection Switch

Request Manual Service Selection Switch
....................................................................................................................................................................................................................................
Purpose
This procedure requests that the service selection of a processor group
be switched.
When to use
Use this procedure when a manual service selection switch of a
processor group is required.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
A manual switch is not permitted with a processor group of one.
Before you begin
Required Tools
• Use of Master Control Center (MCC) or Supplementary Trunk
Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• Refer to Office Record 5880 for provisioned GSMs.
• Refer to Office Record 5883 for provisioned processor groups.
Required Conditions
• The processor group is equipped with two processors.
• One processor in the processor group is SERVING and the other
is NON-SERVING.
Procedure
............................................................................................................................................................
1
Request a manual service selection switch for a specific PSU PH:
SW:SERV,PSUPH=a-c-d-e;
Where:
a = Global switch module number
c = Packet switch unit 2 number
d = PSU2 shelf number
e = PH position number
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-83