Request SCTP Near Endpoint Status
....................................................................................................................................................................................................................................
Purpose
This procedure requests:
• the status of a specific SCTP near endpoint,
• the status of a specific SCTP near endpoint and for all
associations assigned to that near endpoint, or
• the status of all endpoints.
When to use
According to local practices for routine maintenance, use this
procedure to obtain the status of an SCTP near endpoint.
Three procedures are provided to obtain:
1. General status of a specific near endpoint
2. Detailed status on a specific near endpoint
3. Status of all near endpoints
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
None
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• Office Record 5886 to identify endpoint names of a minimum of
one up to a maximum of all provisioned SCTP Near endpoints.
Required Conditions
• None required.
Procedure to Obtain
General Status of Near
Endpoint
............................................................................................................................................................
1
Request a status report for a specific near endpoint:
Maintenance Considerations
....................................................................................................................................................................................................................................
7-8
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
