Insert Packet Group (RC/V 5.71)
....................................................................................................................................................................................................................................
Purpose
The Packet Group view (RC/V 5.71) is used to insert a SIP packet
group. A SIP packet group is used to designate packet trunking to a
given office.
When to use
Use this procedure to add a SIP packet group.
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• Packet Group number
• Bearer network ID
• Far end CLLI
• Near end CLLI
• Hunt type
• Control type
• Association set name or UDP path number
• SIP GSM number
• SIP parameter set name
• SIP PSTN interworking parameter set name
• Preconditioning
• Local audible ringing
Provisioning
....................................................................................................................................................................................................................................
5-82
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
