Lucent Technologies 5ESS - Restore SCTP Near Endpoint

Restore SCTP Near Endpoint
....................................................................................................................................................................................................................................
Purpose
This procedure requests the restoral of an SCTP near endpoint.
When to use
Use this procedure when the restoral of an SCTP near endpoint is
required.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
None
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• None required.
Required Conditions
• Endpoint is
NOSERV or OOS.
Procedure
............................................................................................................................................................
1
Request a restoral of a specific near endpoint :
RST:SCTP,NEAREPT=a;
Where:
a = near endpoint name
Result:
Reports the result of restoring a specific near endpoint to
service.
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-77