Request SCTP Association Set Status
....................................................................................................................................................................................................................................
Purpose
This procedure requests the status of each association in an SCTP
association set.
When to use
According to local routine maintenance practices, use this procedure
to obtain the status of each association in an SCTP association set.
Related information
Refer to the Input Messages Manual, 235-600-700 and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
None
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• Office Record 5890 with a listing of identified association sets.
Required Conditions
• None required.
Procedure
............................................................................................................................................................
1
Request a status report for each association in an association set:
OP:STATUS,SCTP,ASSOCSET=c;
Where:
c = Association set name
Result:
Generates a status report for each association in a specific
association set.
Maintenance Considerations
....................................................................................................................................................................................................................................
7-14
Lucent Technologies 235-200-118
Issue 3.02B, March 2007
To Next Page
Loading...
