Lucent Technologies 5ESS - Analyze SCTP Association Change Report

Analyze SCTP Association Change Report
....................................................................................................................................................................................................................................
Purpose
This procedure provides an analysis of an SCTP association change
report when an SCTP association autonomously transitions from one
state to another.
When to use
Use this procedure to analyze an SCTP association change report.
Related information
Refer to the Input Messages Manual, 235-600-700, and the Output
Messages Manual, 235-600-750, for additional information.
Admonishments
State transitions associated with manual removals or restorals of an
association are not included.
Before you begin
Required Tools
• Use of the Master Control Center (MCC) or Supplementary
Trunk Line Workstation (STLWS).
Required Material
• The switch must be running a 5E16.2 FR3 software release or
later with the SIP for Packet Trunking feature software.
Required Information
• None required.
Required Conditions
• None required.
Procedure
............................................................................................................................................................
1
Analyze the REPT SCTP ASSOCIATION change report generated:
REPT SCTP ASSOC ID=b
NEAR ENDPT=a FAR ENDPOINT=k
PCRGRP=c-d-e PSUPH=c-d-f-g SHELF-CHGRP=f-h
PREV-STATE=i NEW STATE=j
Where:
a = Near endpoint name
b = Association number
c = Switching module number
Maintenance Considerations
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
7-81