Assign QPH Pipe (RC/V 17.24)
....................................................................................................................................................................................................................................
Purpose
The QPH Pipe Assignment (RC/V 17.24) defines the GQPH pipe
connecting the QPH or GQPH to the QLPS network.
When to use
Use this procedure to provision the GQPH pipes for SIPT service.
Repeat individual steps of this procedure as required.
NOTE: This step is not needed for DRM/VCDX..
Related information
Refer to 235-118-258, Recent Change Reference, for information on
the RC/V system and to 235-105-231, Hardware Change Procedures -
Growth.
Admonishments
None.
Before you begin
Required Tools
• Supplemental Trunk Line Workstation (STLWS) or Recent
Change and Verify (RC/V) terminal
• Access to RC/V Menu Interface
Required Material
• The 5ESS
®
switch must be running a 5E16.2 FR3 software
release with the SIP for Packet Trunking - NAR feature software.
Required Information
• GSM number
• PSU Shelf
• Channel Group
• QLPS Network
• Service Type
Required Conditions
• Growth procedures are complete
• Secured Feature 684 is enabled (RC/V 8.22)
• SIP GSM is provisioned (RC/V 5.80)
• Protocol Handler is defined (RC/V 22.4)
• Channel Groups are provisioned for PH33 (RC/V 22.16)
Provisioning
....................................................................................................................................................................................................................................
235-200-118
Issue 3.02B, March 2007
Lucent Technologies
5-23
To Next Page
Loading...
